Thermo Scientific Vanquish VF-D20 Operating Manual page 60

5 • Installation
Page 60
2. Connect the required interface cables to the detector.
If the charged aerosol detector is the only detector in the
♦
Vanquish system
Follow the instructions in the Vanquish System Operating
Manual to set up the USB and system interlink connections in
the system.
♦ If the charged aerosol detector is the second detector in the
Vanquish system, for example after the diode array detector
Set up the USB and system interlink connections as follows (see
Figure 10, page
a) Follow the instructions in the Vanquish System Operating
Manual to connect the other modules in the system up to
the diode array detector.
b) Connect the "B" connector of a USB cable to the USB port on
the charged aerosol detector, and connect the "A"
connector of the USB cable from the charged aerosol
detector to the USB hub on the diode array detector.
c) Connect the "A" connector of the USB cable from the diode
array detector to a USB port (2.0 or higher) on the
computer.
d) Connect one end of the system interlink cable to the free
System Interlink port on the diode array detector, and the
other end to a System Interlink port on the charged aerosol
detector.
e) Connect one end of the system interlink cable to the free
System Interlink port on the charged aerosol detector, and
the other end to a System Interlink port on the column
compartment.
Vanquish Charged Aerosol Detectors Operating Manual
61):