5
•
Installation
Guide Holes
Page 72
In each module, push the tube (or capillary) into the appropriate guide
(see picture).
Figure 19: Tubing chase with tubing guides (left: view from inside, right:
view from top)
No.
Use for
1
Solvent tubing (up to three solvent lines, preferably routed to the upper
degas chambers)
2
Solvent tubing (up to three solvent lines)
3
Wash liquid tubing (seal wash, autosampler needle wash)
4
Detector waste capillary
Tubing brackets are available for holding the tubing in place. Slip the
bracket side onto the drain pipe, and clamp the other side behind the
front panel (see picture).
Figure 20: Tubing bracket (left), tubing bracket installed (right)
Guide holes are provided at specific positions in the device housings.
Route flow connections from one module to the next module in the
Vanquish system through the appropriate guide hole when instructed to
do so in the manual.
Vanquish Charged Aerosol Detectors Operating Manual