Thermo Scientific Vanquish VF-D20 Operating Manual page 68

5 • Installation
Page 68
2. Connect the gas exhaust tubing to the ventilation and route it to the
detector.
3. Check the length of the gas tubes.
The gas tubes should go straight to the detector. If the gas tubes are
longer than required, use a tubing cutter to cut the tubes straight to
the required length. Make sure that the cut is at a right angle to the
length of the gas tubes.
4. Connect the gas tubes to the elbow connectors. Mind the correct
orientation of the elbow connectors (see
a) Connect the gas inlet tubing to the gas inlet elbow connector.
b) Connect the gas exhaust tubing to the gas exhaust elbow
connector.
Figure 17: Connecting gas tubes to the elbow connectors
No. Description
1 Connection stem to gas inlet port
2 Connector for gas inlet tubing
3 Gas inlet tubing
Vanquish Charged Aerosol Detectors Operating Manual
Figure 17).
No. Description
4 Connection stem to gas exhaust port
5 Connector for gas exhaust tubing
6 Gas exhaust tubing