Set The Beeper Status (Beep); Set The Power-On State (Poweron) - ITech IT6000C Series User Manual

5.5 Set the Beeper Status (Beep)

The user can turn the instrument beeper sound on or off base on personal
requirement.
The beeper sound works in the following scenarios:
•
•
•
The setting procedures are as follows:
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
2. Press [Enter] key to enter the parameter setting interface.
3. Press the Left / Right key or turn the knob to adjust the value of this
4. After the parameter settings are complete, press [Enter].

5.6 Set the Power-on State (PowerOn)

This menu item is used to control the settings and output state when the power
supply is powered on.
The detailed power-on parameters and output state are as follows.
•
•
•
The procedures to set the menu item are as follows.
A beeper sound produced when the front panel key is pressed.
When an error is generated inside the instrument, such as when the instru-
ment receives an unprocessable command in the remote state. At this time,
the instrument produces a beeper sound, and the flag "Error" appears on the
VFD.
When the instrument is under protection status, such as over-temperature
protection. At this time, the instrument produces the beeper sound.
ter the system menu.
The first displayed menu item Beep is used to set the beeper status.
parameter.
•
On: Default value, indicates the beeper is on.
•
Off: Indicates the beeper is off.
At this point, the beeper status takes effect immediately.
The voltage, current, power setting values displayed on the main interface
when the instrument is powered on.
Parameter setting values in the Config menu.
The output state of the power supply, i.e., the [On/Off] key state.
Copyright © Itech Electronic Co., Ltd.
Basic Operation
105