Setting Up The Report Header; Setting Up The Report Type; Resetting Printer To Default; Loading Paper In The Onboard Printer - Siemens DCA Vantage Operator's Manual

Setting up the Report Header

For information about setting up the optional report header, see Customizing
Printed Report Headers‚ page 164.

Setting up the Report Type

For information about setting the optional report type, see Setting the Printed
Patient Test Report Type‚ page 165.

Resetting Printer to Default

1. At the Home screen, select
2. At the System Settings menu, select
3. At the Additional Settings menu, select
4. Select
Reset Printer Defaults
This also deletes any report header text you have created.

Loading Paper in the Onboard Printer

Install a roll of printer paper for the onboard printer and reinstall the printer
cover. Refer to Loading Paper on the Onboard Printer‚ page 111.
The printer stops printing when it runs out of paper. If no paper is available at
the start of printing, the printer does not attempt to print.

Software Setup

After the system is properly installed, start the DCA Vantage system by
toggling the power button to the On position. The system displays the
following information:
• Model Name
• System Software Version
• Copyright Information

Start Up Tests

After you turn the power on, a message displays explaining that the system is
starting up. The DCA Vantage system verifies that the compartment door is
closed and performs hardware functionality tests to verify that the internal
optics and the mechanical system are operating correctly.
CAUTION
Do not turn the system off while it is starting up, this can cause
corruption to the stored data.
DCA Vantage Operator's Guide
.
System Settings
Additional Settings
.
Printers
to restore the default printer settings.
.
31