Troubleshooting; System Messages - Siemens DCA Vantage Operator's Manual

7

Troubleshooting

If an operational or system problem occurs, use the information in this section
to correct the problem.
If you are unable to resolve the problem or have questions, contact your local
technical support provider or distributor.

System Messages

System messages provide status and prompts to assist you while using the
DCA Vantage system.
System Message
A/C High control test failed. You
cannot perform A/C patient tests.
A/C High control test requested by
remote computer.
A/C High control test requested by
remote computer. Patient test locked
until the control test is run.
A/C Low control test failed. You
cannot perform A/C patient tests.
A/C Low control test requested by
remote computer.
A/C Low control test requested by
remote computer. Patient test locked
until the control test is run.
Access Code is already in use.
An optical test is required.
DCA Vantage Operator's Guide
Comment
The albumin and creatinine quality
control test failed. You must have a
successful control test to perform
patient tests.
A computer connected to the system
is sending a request for a test.
A computer connected to the system
is sending a request for a QC test.
You must wait to run the patient test
until the control test completes.
The albumin and creatinine quality
control test failed. You must have a
successful control test to perform
patient tests.
A computer connected to the system
is sending a request for a test.
A computer connected to the system
is sending a request for a QC test.
You must wait to run the patient test
until the control test completes.
A reminder message that it is time to
run the Optical Test using the Optical
Test Cartridge. The frequency of the
reminder is determined by your
location.
121