Disabling The External Barcode Reader; Restoring The Barcode Reader Default Settings; Testing The External Barcode Reader - Siemens DCA Vantage Operator's Manual

7. Select
System Settings
8. From the System Settings menu, select
9. Select
External Barcode Reader
• If using an Interleaved 2 of 5 barcode, select the I2of5 checkbox.
• If using any other barcode, select the Other checkbox.
10. If you are using a check digit, select
11. To save the external barcode reader settings, select
You can enable or disable a beep to sound after a successful barcode code
scan. In Release 3.0, the beep is enabled by default. In earlier versions, the
beep was disabled by default. Print these barcodes on a high-quality printer
and scan to enable or disable the beep.
Beep after good code: Enable

Disabling the External Barcode Reader

1. At the Home screen, select
2. Select
System Settings
3. At the System Settings menu, select
4. At the Additional Settings menu, select
5. Select .
Disabled
6. To save the external barcode reader settings, select

Restoring the Barcode Reader default settings

1. Leave the barcode scanner connected to the DCA Vantage system.
2. Turn the system off from the Home screen.
3. Turn the system power switch to the off position.
4. Turn the system power switch to the on position to restart the system.

Testing the External Barcode Reader

Use the barcodes in this section to test each symbology with the barcode
reader. Ensure that your external barcode reader has been correctly installed
using the procedure in Installing the External Barcode Reader‚ page 194.
Ensure that the barcoded labels used in your laboratory comply with the
specifications given in this section.
DCA Vantage Operator's Guide
from the Menu screen.
Additional Settings.
.
Check Digit
Beep after good code: Disable
.
Menu
from the Menu screen.
Additional Settings
External Barcode Reader
.
.
Save
.
.
.
Save
195