Siemens DCA Vantage Operator's Manual page 123

System Message
Operator ID is already in use.
Perform A/C High control test.
Perform HbA1c Normal control test.
Perform A/C Low control test.
Perform an Optical Test.
Perform HbA1c Abnormal control test.
Processing restricted, not ready for
current command.
Remote command received to lockout
patient testing.
Requested data was not found.
Serial Number is not defined. Contact
your technical support provider.
Test cancelled due to cartridge load
timeout.
The access code entered is not valid
or access is denied. Please check
with your supervisor.
The activation key entered does not
match any feature.
The database was corrupt and
recovered from the system backup.
Some data may be lost.
The Door is open, to continue close
the door.
The motor must be homed. Run the
Motor Control Test.
The system door was open during the
test.
The system is in diagnostics mode.
The system is warming up.
This field must have at least one
alphanumeric character.
DCA Vantage Operator's Guide
Comment
The values you searched for are not in
the system.
The serial number for your system is
not in the system software.
The test was not started within the
time limit.
The key code you entered is not
correct.
The cartridge door was opened. The
system will not continue processing
tests until the door is securely closed.
During a patient, control, or QC test,
the cartridge door was opened. Close
the door.
The system was powered on or power
save mode was active.
123