Setup Express - Cisco Catalyst 3550 Command Reference Manual

Chapter 2 Cisco IOS Commands

setup express

Use the setup express global configuration command to enable Express Setup mode on the switch. This
is the default setting. Use the no form of this command to disable Express Setup mode.
Syntax Description
This command has no arguments or keywords.
Defaults Express Setup is enabled.
Command Modes
Global configuration
Command History Release
12.1(14)EA1
Usage Guidelines
When Express Setup is enabled on a new (unconfigured) switch, pressing the Mode button for 2 seconds
activates Express Setup. You can access the switch through an Ethernet port by using the IP address
10.0.0.1 and then can configure the switch with the web-based Express Setup program or the
command-line interface (CLI)-based setup program.
When you press the Mode button for 2 seconds on a configured switch, the mode LEDs start blinking.
If you press the Mode button for a total of 10 seconds, the switch configuration is deleted, and the switch
reboots. The switch can then be configured like a new switch, either through the web-based Express
Setup program or the CLI-based setup program.
As soon as you make any change to the switch configuration (including entering no at the beginning of
Note
the CLI-based setup program), configuration by Express Setup is no longer available. You can only run
Express Setup again by pressing the Mode button for 10 seconds. This deletes the switch configuration
and reboots the switch.
If Express Setup is active on the switch, entering the write memory or copy running-configuration
startup-configuration privileged EXEC commands deactivates Express Setup. The IP address 10.0.0.1
is no longer valid on the switch, and your connection using this IP address ends.
The primary purpose of the no setup express command is to prevent someone from deleting the switch
configuration by pressing the Mode button for 10 seconds.
78-11195-09
setup express
no setup express
Modification
This command was introduced.
Catalyst 3550 Multilayer Switch Command Reference
setup express
2-225