Cisco Catalyst 3550 Command Reference Manual page 280

show dot1x
This is an example of output from the show dot1x statistics interface fastethernet 0/3 command.
Table 2-17
Switch# show dot1x statistics interface fastethernet 0/3
PortStatistics Parameters for Dot1x
--------------------------------------------
TxReqId = 15
RxStart = 4
RxInvalid = 0
RxVersion = 1
Table 2-17 show dot1x statistics Field Descriptions
Field
TxReqId
TxReq
TxTotal
RxStart
RxLogoff
RxRespId
RxResp
RxInvalid
RxLenErr
RxTotal
RxVersion
LastRxSrcMac
Related Commands Command
dot1x default
Catalyst 3550 Multilayer Switch Command Reference
2-254
describes the fields in the display.
TxReq = 0 TxTotal = 15
RxLogoff = 0 RxRespId = 1
RxLenErr = 0 RxTotal= 6
LastRxSrcMac 00d0.b71b.35de
Description
Number of Extensible Authentication Protocol (EAP)-request/identity
frames that have been sent.
Number of EAP-request frames (other than request/identity frames) that
have been sent.
Number of Extensible Authentication Protocol over LAN (EAPOL)
frames of any type that have been sent.
Number of valid EAPOL-start frames that have been received.
Number of EAPOL-logoff frames that have been received.
Number of EAP-response/identity frames that have been received.
Number of valid EAP-response frames (other than response/identity
frames) that have been received.
Number of EAPOL frames that have been received and have an
unrecognized frame type.
Number of EAPOL frames that have been received in which the packet
body length field is invalid.
Number of valid EAPOL frames of any type that have been received.
Received packets in the 802.1X version 1 format.
Source MAC address carried in the most recently received EAPOL
frame.
Description
Resets the configurable 802.1X parameters to their default values.
Chapter 2 Cisco IOS Commands
RxResp = 1
78-11195-09