Cisco Catalyst 3550 Command Reference Manual page 303

Chapter 2 Cisco IOS Commands
Command History Release
12.1(4)EA1
12.1(12c)EA1
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show interfaces gigabitethernet0/1 command.
Switch# show interfaces gigabitethernet0/1
GigabitEthernet0/1 is up, line protocol is up
Hardware is Gigabit Ethernet, address is 0002.4b29.4401 (bia 0002.4b29.4401)
MTU 1500 bytes, BW 100000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 100Mb/s
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:08, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 1000 bits/sec, 2 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
78-11195-09
Modification
This command was first introduced.
The capabilities keyword was added.
reliability 255/255, txload 1/255, rxload 1/255
7122 packets input, 783062 bytes, 0 no buffer
Received 5137 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
9222 packets output, 2188728 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 1 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Catalyst 3550 Multilayer Switch Command Reference
show interfaces
2-277