Cisco Catalyst 3550 Command Reference Manual page 244

service-policy
Examples
This example shows how to apply plcmap1 to an ingress interface:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# service-policy input plcmap1
This example shows how to apply plcmap2 to an egress interface:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# service-policy output plcmap2
This example shows how to detach plcmap2 from an interface2:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# no service-policy input plcmap2
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command
policy-map
show policy-map
Catalyst 3550 Multilayer Switch Command Reference
2-218
Description
Creates or modifies a policy map that can be attached to multiple interfaces
to specify a service policy.
Displays quality of service (QoS) policy maps.
Chapter 2 Cisco IOS Commands
78-11195-09