Police Aggregate - Cisco Catalyst 3550 Command Reference Manual

police aggregate

police aggregate
Use the police aggregate policy-map class configuration command to apply an aggregate policer to
multiple classes in the same policy map. Use the no form of this command to remove the specified
policer.
Syntax Description
aggregate-policer-name
Defaults No aggregate policers are defined.
Command Modes
Policy-map class configuration
Command History Release
12.1(4)EA1
Usage Guidelines
You set aggregate policer parameters by using the mls qos aggregate-policer global configuration
command.
You can configure up to 128 policers on ingress Gigabit-capable Ethernet ports.
You can configure up to eight policers on ingress 10/100 Ethernet ports.
You can configure up to eight policers on egress ports.
You apply an aggregate policer to multiple classes in the same policy map; you cannot use an aggregate
policer across different policy maps or interfaces.
Policy maps that contain per-port per-VLAN classification commands cannot be applied to egress
interfaces.
To return to policy-map configuration mode, use the exit command. To return to privileged EXEC mode,
use the end command.
Catalyst 3550 Multilayer Switch Command Reference
2-198
police aggregate aggregate-policer-name
no police aggregate aggregate-policer-name
Modification
This command was first introduced.
Name of the aggregate policer.
Chapter 2 Cisco IOS Commands
78-11195-09