Cisco Catalyst 3550 Command Reference Manual page 216

pagp learn-method
Examples
This example shows how to set the learning method to learn the address on the physical port within the
EtherChannel:
Switch(config-if)# pagp learn-method physical-port
This example shows how to set the learning method to learn the address on the port-channel within the
EtherChannel:
Switch(config-if)# pagp learn-method aggregation-port
You can verify your settings by entering the show running-config privileged EXEC command or the
show pagp channel-group-number internal privileged EXEC command.
Related Commands Command
pagp port-priority
show pagp
show running-config
Catalyst 3550 Multilayer Switch Command Reference
2-190
Description
Selects an interface over which all traffic through the EtherChannel is sent.
Displays PAgP channel-group information.
Displays the current operating configuration. For syntax information, select
Cisco IOS Configuration Fundamentals Command Reference for
Release 12.1 > Cisco IOS File Management Commands > Configuration File
Commands.
Chapter 2 Cisco IOS Commands
78-11195-09