Mvr (Interface Configuration) - Cisco Catalyst 3550 Command Reference Manual

mvr (interface configuration)

mvr (interface configuration)
Use the mvr interface configuration command to configure a Layer 2 port as a multicast VLAN
registration (MVR) receiver or source port, to set the Immediate Leave feature and to statically assign a
port to an IP multicast VLAN and IP address. Use the no form of this command to return to the default
settings.
Syntax Description
immediate
type
receiver
source
vlan vlan-id group
ip-address
Defaults A port is configured as neither a receiver nor a source.
The Immediate Leave feature is disabled on all ports.
No receiver port is a member of any configured multicast group.
Command Modes
Interface configuration
Command History Release
12.1(4)EA1
Catalyst 3550 Multilayer Switch Command Reference
2-186
mvr {immediate | type {receiver | source} | vlan vlan-id group ip-address}
no mvr {immediate | type {source | receiver}| vlan vlan-id group [ip-address]}
(Optional) Enable the Immediate Leave feature of MVR on a port. Use
the no mvr immediate command to disable the feature.
(Optional) Configure the port as an MVR receiver port or a source port.
The default port type is neither an MVR source nor a receiver port. The
no mvr type command resets the port as neither a source or a receiver
port.
Configure the port as a subscriber port that can only receive multicast
data. Receiver ports cannot belong to the multicast VLAN.
Configure the port as an uplink port that can send and receive multicast
data for the configured multicast groups. All source ports on a switch
belong to a single multicast VLAN.
(Optional) Statically configure the specified MVR IP multicast group
address for the specified multicast VLAN ID. This is the IP address of the
multicast group that the port is joining. If the entered VLAN is not the
multicast VLAN, an error message is reported.
The no mvr vlan group command removes a port on a VLAN from
membership in an IP multicast address group. With the no form, the IP
address is optional; when no IP address is entered, the specified port is
removed from membership in all configured multicast groups.
Modification
This command was first introduced.
Chapter 2 Cisco IOS Commands
78-11195-09