Cisco Catalyst 3550 Command Reference Manual page 416

show vtp
Table 2-27 show vtp counters Field Descriptions (continued)
Field
Number of V1 summary
errors
Join Transmitted
Join Received
Summary Advts Received
from non-pruning-capable
device
This is an example of output from the show vtp status command.
display.
Switch> show vtp status
VTP Version
Configuration Revision
Maximum VLANs supported locally : 1005
Number of existing VLANs
VTP Operating Mode
VTP Domain Name
VTP Pruning Mode
VTP V2 Mode
VTP Traps Generation
MD5 digest
Configuration last modified by 0.0.0.0 at 0-0-00 00:00:00
Local updater ID is 172.20.135.196 on interface Vl1 (lowest numbered VLAN interface found)
Table 2-28 show vtp status Field Descriptions
Field
VTP Version
Configuration Revision
Maximum VLANs
Supported Locally
Number of Existing
VLANs
Catalyst 3550 Multilayer Switch Command Reference
2-390
Description
Number of version 1 errors.
Version 1 summary errors increment whenever a switch in VTP V2 mode
receives a VTP version 1 frame. These errors mean that at least one
neighboring switch is either running VTP version 1 or VTP version 2
with V2-mode disabled. To solve this problem, change the configuration
of the switches in VTP V2-mode to disabled.
Number of VTP pruning messages sent on the trunk.
Number of VTP pruning messages received on the trunk.
Number of VTP summary messages received on the trunk from devices
that do not support pruning.
: 2
: 0
: 5
: Server
:
: Disabled
: Disabled
: Disabled
: 0xBF 0x86 0x94 0x45 0xFC 0xDF 0xB5 0x70
Description
Displays the VTP version operating on the switch. By default, the switch
implements version 1 but can be set to version 2.
Current configuration revision number on this switch.
Maximum number of VLANs supported locally.
Number of existing VLANs.
Chapter 2 Cisco IOS Commands
Table 2-28 describes each field in the
78-11195-09