Police Aggregate - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series NX-OS Quality of Service Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

police aggregate

To apply an aggregate policer to a particular class of traffic across multiple interfaces, use the police
aggregate command. To remove an aggregate policer configuration, use the no form of this command.
Syntax Description
policer-name
Defaults None
Command Modes Policy map type qos class configuration
Supported User Roles
network-admin
vdc-admin
Command History Release
4.0
Usage Guidelines Shared policers can only be applied to interfaces on the same module.
For information about configuring a shared policer, see the
Note
This command does not require a license.
Examples
This example shows how to configure a shared policer for the class-default class of traffic:
switch(config)# policy-map my_policy1
switch(config-pmap-qos)# class default-class
switch(config-pmap-c-qos)# police aggregate my_aggregate_policer
switch(config-pmap-c-qos)#
This example shows how to remove the configuration of a shared policer from the class-default class of
traffic:
switch(config)# policy-map my_policy1
switch(config-pmap-qos)# class default-class
switch(config-pmap-c-qos)# no police aggregate my_aggregate_policer
switch(config-pmap-c-qos)#
OL-23378-01
police aggregate policer-name
no police aggregate policer-name
Name of a shared aggregate policer to use.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS Quality of Service Command Reference, Release 5.x
qos shared-policer command.
police aggregate
QOS-47