Police Aggregate - Cisco Catalyst 2960 Command Reference Manual

police aggregate

police aggregate
To use this command, the switch must be running the LAN Base image.
Note
Use the police aggregate policy-map class configuration command to apply an aggregate policer to
multiple classes in the same policy map. A policer defines a maximum permissible rate of transmission,
a maximum burst size for transmissions, and an action to take if either maximum is exceeded. Use the
no form of this command to remove the specified policer.
Syntax Description
aggregate-policer-name
Defaults No aggregate policers are defined.
Command Modes Policy-map class configuration
Command History Release
12.2(25)FX
Usage Guidelines The port ASIC device, which controls more than one physical port, supports 256 policers (255
user-configurable policers plus 1 policer reserved for internal use). The maximum number of
user-configurable policers supported per port is 63. Policers are allocated on demand by the software and
are constrained by the hardware and ASIC boundaries. You cannot reserve policers per port. There is no
guarantee that a port will be assigned to any policer.
You set aggregate policer parameters by using the mls qos aggregate-policer global configuration
command. You apply an aggregate policer to multiple classes in the same policy map; you cannot use an
aggregate policer across different policy maps.
To return to policy-map configuration mode, use the exit command. To return to privileged EXEC mode,
use the end command.
You cannot configure aggregate policers in hierarchical policy maps.
Catalyst 2960 Switch Command Reference
2-262
police aggregate aggregate-policer-name
no police aggregate aggregate-policer-name
Modification
This command was introduced.
Name of the aggregate policer.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
OL-8604-04