Installing A Switch Using The At-Brkt-J22 Wall Mount Kit; What To Prepare; Installing A Switch Using The At-Brkt-J22 Brackets - Allied Telesis AT-GS920/16 Installation And User Manual

Installing a Switch Using the AT-BRKT-J22 Wall Mount Kit

What to Prepare

Installing a
Switch Using the
AT-BRKT-J22
Brackets
This section shows you steps to install a switch on a wall using the
AT-BRKT-J22 kit.
Before installing a switch on a wall, make sure that the following items are
ready.
An AT-BRKT-J22 wall mount kit

Eight screws to attach the brackets to a wall

Eight plastic anchors for the screws

Phillips-head screwdriver

Pencil

Note
Screws and plastic anchors are not included in the shipping box.
You must provide screws that hold the switch securely to the wall.
To install the switch on a wall, perform the following procedure:
1. If the rubber feet were previously installed, remove them as shown in
Figure 57.
Figure 57. Removing AT-GS920/24 Rubber Feet
2. Orient the brackets against the sides of the switch.
Chapter : AT-GS920/24 Switch Wall Mount Installation
103