Table of Contents
Advertisement
Figure 26. Attaching Cable Tray to Plates
6. Turn the switch over and place it on the work table.
7. Attach the units in Step 5 to the switch with M3x6mm screws using a
Phillip-head screw driver as shown in Figure 27.
Figure 27. Attaching the Plates to the Switch
8. Mount the switch in a standard 19-inch equipment rack with four
equipment rack screws as shown in Figure 28 on page 56.
Note
The screws are not included in the AT-RKMT-J05 rack mount kit.
Chapter 2: Hardware Installation
55
Advertisement
Table of Contents
