Installing A Gs970M/18, Gs970M/28 Or At-Gs970M Ps Series Switch On A Wall; Figure 41: Attaching Wall Mount Brackets To The Side Of The Switch - Allied Telesis CentreCOM GS970M Series Installation Manual

Installing a GS970M/18, GS970M/28 or AT-GS970M PS Series switch
on a wall
These instructions show you how to install a GS970M/18, GS970M/28 or
AT-GS970M PS Series switch on a wall. The wall mount kit is AT-BRKT-
J24 and can be purchased separately from your Allied Telesis dealer.
Note
This section shows a GS970M/10PS switch as an example.
Before you start, ensure that the wall is sturdy enough to hold the switch's
weight. You may need to position the switch so that it can be screwed into
the wall's framing timber or an equivalent structural element.
To install the switch on a wall, perform the following procedure:
1. If the rubber feet are attached to the bottom of the switch, remove
them with a screwdriver (Figure 25 on page 55), then turn the switch
back over.
2. Orient the brackets against the sides of the switch as shown in Figure
41, and secure them to the unit with the 16 brackets screws included in
the wall mount kit.
F 41. A
IGURE TTACHING WALL MOUNT BRACKETS TO THE SIDE OF THE SWITCH
GS9790M Series Switch Installation Guide
67