Figure 39: Installing The At-Gs924Mpx, At-Gs948Mx, Or At-Gs948Mpx Switch On A Wall - Allied Telesis AT-GS924MX Installation Manual

Chapter 4: Installing the Switch on a Wall
86
4. Place the switch on a table or desk.
5. Use a drill and a 1/4" carbide drill bit to pre-drill the two holes you
marked in Step 3. Please review the following guidelines:
Prior to drilling, set the drill to hammer-and-rotation mode. This

breaks up the concrete and cleans out the hole.
Allied Telesis recommends cleaning out the holes with a brush or

compressed air.
6. Insert the two anchors into the holes.
7. Have another person hold the switch at the selected wall location while
you secure it to the wall with the two provided screws. See Figure 39.
Figure 39. Installing the AT-GS924MPX, AT-GS948MX, or
AT-GS948MPX Switch on a Wall