Table of Contents
Advertisement
GS920 Series Gigabit Ehternet Switch Installation and User's Guide
Energy Efficiency
Ethernet (EEE)
DIP switch # 2 enables or disables the EEE feature. See Figure 42, "Front
Panel Configuration Switches and LEDs" on page 72 for the DIP switch
location on the front panel.
Enabling EEE
Perform the following procedure to enable the EEE feature:
1. Set DIP switch # 2 to the UP position to enable this feature. See
Figure 45.
Figure 45. DIP Switch Settings for Enabling EEE
2. Turn the power OFF by unplugging the AC power cord and then back
ON again by reconnecting it to the AC outlet on the switch. The new
switch setting is now implemented and effective and the EEE energy
saving behavior is now enabled for all the Ethernet ports.
Note
A recently changed DIP switch setting becomes effective ONLY
after you turn the switch's AC power OFF and then back ON.
EEE is supported only at 100M/1000M link speed with
Auto-Negotiation enabled. For supported and unsupported speed/link
port configurations, see Table 19, "EEE Support for Port Speed/Link
Configuration" on page 77.
76
Advertisement
Table of Contents
