Table of Contents
Advertisement
2. Turn the power OFF by unplugging the AC power cord and then back
ON again by reconnecting it to the AC outlet on the switch. The new
switch setting is now implemented and effective and Flooding is
enabled on all of the Ethernet ports.
Note
A recently changed DIP switch setting becomes effective ONLY
after you turn the switch's AC power OFF and then back ON.
Disabling Flooding
Perform the following procedure to disable the Flooding feature:
1. Set DIP switch # 4 to the DOWN position. See Figure 50.
Figure 50. DIP Switch Settings for Disabling Flooding
2. Turn the power OFF by unplugging the AC power cord and then back
ON again by reconnecting it to the AC outlet on the switch. The new
configuration is now implemented and effective and the Flooding
feature is disabled.
Note
A recently changed DIP switch setting becomes effective ONLY
after you turn the switch's AC power OFF and then back ON.
Chapter 4: Switch Configuration
81
Advertisement
Table of Contents
