Feature Configuration; Multicast Frame Pass-Through - Allied Telesis AT-GS920/16 Installation And User Manual

Feature Configuration

Multicast Frame
Pass-Through
The following features can be configured with the individual DIP switches:

"Multicast Frame Pass-Through"


"Energy Efficiency Ethernet (EEE)" on page 76

"Loop Prevention" on page 78

"Flooding" on page 80

"Flow Control" on page 82

These features can be set on all ports on the switch or on individual ports.
DIP switch # 1 enables or disables the Multicast Frame Pass-Through
feature. See Figure 42, "Front Panel Configuration Switches and LEDs" on
page 72 for the DIP switch location on the front panel.
Note
The Flooding feature has priority over Multicast Frame
Pass-Through feature when both are enabled. If you prefer to have
the Multicast Frame Pass-Through feature enabled, the Allied
Telesis recommends that you disable the Flooding feature. See
"Disabling Flooding" on page 81 for more information.
Enabling Multicast Frame Pass-Through
Perform the following procedure to enable the Multicast Frame
Pass-Through feature:
1. Set DIP switch # 1 to the UP position to enable this feature. See Figure
43 on page 74.
Chapter 4: Switch Configuration
73