Table of Contents
Advertisement
Figure 55. DIP Switch Settings for Configuring an Individual Port
3. Press the NEXT PORT button to select the port you want to configure.
Each time you press the NEXT PORT button, the next port is selected.
When a port is selected, its SDP/LOOP LED flashes indicating that this
port is ready to be configured.
4. Push the MODE button for less than 1 second to select a
pre-configured port configuration setting.
You can select one from six pre-configured settings;
– Auto-Negotiation
– 1000M in full duplex
– 100M in full duplex
– 100M in half duplex
– 10M in full duplex
– 10M in half duplex.
Each time you press the MODE button, the port configuration
advances to the next pre-configured setting in the sequence. Figure 54
on page 86 shows the sequence and each MODE LEDs display.
Note
The FORCE_MDI / MODE push button is a dual purpose button.
When it is pressed for less than one second, it advances the
configuration port settings for speed and duplex. When it is pressed
for more than one second, the configuration is toggled between
Force MDI/MDI-X and Auto MDI/MDI-X.
Chapter 4: Switch Configuration
87
Advertisement
Table of Contents
