Table of Contents
Advertisement
Chapter 3: Installing the AT-GS920/8PS Switch
66
Note
You must provide flat-head and cross-head screwdrivers.
To install the switch in one row of the equipment rack, perform the
following procedures.
Caution
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack.
Attention
Le châssis peut être lourd et difficile à soulever. Allied Telesis
recommande de demander de l'assistance lors de l'installation d'un
châssis dans un rack.
1. Review "Selecting a Site for the Switch" on page 36 to verify the
suitability of the site for the switch.
2. Attach the handles to the brackets as shown in Figure 36.
Figure 36. Attaching the Handles to the Brackets
E28
E28
Advertisement
Table of Contents
