Installing the Switch on a Table or Desktop
To install the switch on a table or desktop, perform the following
procedure:
1. Remove all the items from the packaging.
2. Store the packaging material in a safe place.
In the event a problem occurs and you need to return the unit, use as
much of the original shipping material as possible.
3. Install the four rubber feet with the four screws provided on the bottom
of the switch chassis. See Figure 11.
Figure 11. Installation of Rubber Feet
4. Place the switch on a flat and secure surface with the rubber feet firmly
on the table or desktop, leaving a minimum of 4" around the switch for
ventilation.
5. Proceed to "Cabling the Switch" on page 57 for the cable installation.
Chapter 2: Hardware Installation
43