Table of Contents
Advertisement
Disabling Loop Prevention
Perform the following procedure to disable the Loop Prevention feature:
1. Set DIP switch # 3 to the DOWN position. See Figure 48.
Figure 48. DIP Switch Settings for Disabling Loop Prevention
2. Turn the power OFF by unplugging the AC power cord and then back
ON again by reconnecting it to the AC outlet on the switch. The new
configuration is now implemented and effective and the Loop
Prevention feature is disabled.
Note
A recently changed DIP switch setting becomes effective ONLY
after you turn the switch's AC power OFF and then back ON.
The Loop Prevention LED should be OFF indicating that the feature is
disabled.
Chapter 4: Switch Configuration
79
Advertisement
Table of Contents
