Table of Contents
Advertisement
Wall Installation
of AT-GS920/24
To install the AT-GS920/24 switch on a wall for all installations everywhere
except in Japan, perform the following procedure:
Note
To install the AT-GS920/24 switch on a wall in Japan, see
"AT-GS920/24 Switch Wall Mount Installation" on page 101 for the
installation instructions using the AT-BRKT-J22 Wall Mount Kit
separately.
1. Place all the items from the packaging on a work table.
2. If the rubber feet were previously installed, turn the switch over with the
top side down and remove the rubber feet on the bottom of the switch
using a Phillips-head screwdriver.
Figure 12. Removing Feet From the Chassis Bottom
3. Turn the switch over with the top side up.
4. Orient the brackets against the sides of the switch and secure them to
the switch with the four screws provided as shown in Figure 13.
Figure 13. Attaching the Brackets to the AT-GS920/24 Switch
5. Have another person hold the switch with the brackets at the wall
location where the switch is to be installed, while you use a pencil to
mark the wall with the locations of the four holes in the brackets. See
Figure 14 as an example.
Chapter 2: Hardware Installation
45
Advertisement
Table of Contents
