Allied Telesis AT-GS920/16 Installation And User Manual page 54

GS920 Series Gigabit Ehternet Switch Installation and User's Guide
Install a AT-GS920/16 or AT-GS920/8 Switch Using the
AT-RKMT-J05 or AT-RKMT-J08 Rack Mount Kit
This section gives the steps to install a switch in an equipment rack using
the AT-RKMT-J05 or AT-RKMT-J08 kit.:
Note
The installation procedures are illustrated using the AT-RKMT-J05
rack mount kit as an example.
1. Place all the items from the packaging on a work table.
2. Remove the rubber feet if previously installed.
3. Attach the handle to the short bracket with M3x6mm screws using a
Phillip-head screw driver as shown in Figure 24.
Figure 24. Attaching Handles to Brackets
4. Attach the short bracket and handle to the long bracket with M4x6mm
screws using a Phillip-head screw driver as shown in Figure 25.
Figure 25. Attaching Brackets to Plates
5. Attach the cable bracket to the unit that you assembled in Step 4 with
M4x6mm screws using a Phillip-head screw driver as shown in
Figure 26.
54