AT-DC2552XS / L3 Enterprise Core Switch Installation Guide
Caution
The PSU blank cover should be installed if an AT-PWR06 power sup-
ply module is not present in the chassis. This blank cover assures
that the correct airflow across the components in the chassis when a
power supply module is not installed. Refer to "Installing Power Sup-
ply Blank Cover" on page 63.
4. Slowly insert the AT-PWR06 power supply module into the PSU slot
until it is flush with the rear of the chassis. See Figure 25.
Figure 25. Insert AT-PWR06 Module Into Chassis
61