Verifying Member Switches; Figure 82: Show Stack Command For A Member Switch - Allied Telesis AlliedWare Plus Installation Manual

Verifying
Member Switches
awplus# show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
2 -
Operational Status
Stack MAC address
Perform this procedure to verify the configuration of a member switch.
1. Start a new local management session on the switch. Refer to
"Starting a Local Management Session" on page 142.
2. Move to the Privileged Exec mode with the ENABLE command.
awplus> enable
awplus#
3. Enter the SHOW STACK command. Figure 80 is an example of a
member switch with the ID number 2.:
MAC address
-
nnnn.nnnn.nnnn
Figure 82. SHOW STACK Command for a Member Switch
4. Check the display for the following:
The values for the ID 1 row should be blank. This default

provisioned entry will be used by the master switch when you
power on the stack.
The member's Switch ID should be the number you assigned it in

Part I.
5. Enter the SHOW RUNNING-CONFIG INTERFACE command to
display the port configuration on the member switch. Confirm that the
correct Gigabit ports on the member switch have the STACKPORT
command, designating them as the trunk: Refer to Figure 83 on page
182 for an example.
x930 Series Installation Guide for Virtual Chassis Stacking
Priority Status
-
128 Ready
Standalone unit
nnnn.nnnn.nnnn
Role
Provisioned
Active Master
181