HEIDENHAIN TNC 620 User Manual page 460

12
Parameter settings
NC stop during tool check
NC stop during tool measurement
Change the tool table during tool check and tool measurement
Configuration of a round stylus
TT140_1
Coordinates of the stylus center
Set-up clearance above the stylus for pre-positioning
Safety zone around the stylus for prepositioning
460
True: When the breakage tolerance is exceeded, the NC program is stopped
False: The NC program is not stopped
True: When the breakage tolerance is exceeded, the NC program is stopped
False: The NC program is not stopped
AdaptOnMeasure: The table is changed after tool measurement
AdaptOnBoth: The table is changed after tool check and tool measurement
AdaptNever: The table is not changed after tool check and tool measurement
[0]: X coordinate of the stylus center with respect to the machine datum
[1]: Y coordinate of the stylus center with respect to the machine datum
[2]: Z coordinate of the stylus center with respect to the machine datum
0.001 to 99 999.9999 [mm]: Set-up clearance in tool-axis direction
0.001 to 99 999.9999 [mm]: Set-up clearance in the plane perpendicular to the
tool axis
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
Tables and Overviews | Machine-specific user parameters