Comparison: Differences In Mdi Operation - HEIDENHAIN TNC 620 User Manual

Tables and Overviews | Differences between the TNC 620 and the iTNC 530

Comparison: Differences in MDI operation

Function
Miscellaneous functions
Skip NC blocks
Comparison: Differences in programming station
Function
Demo version
Demo version
Demo version
Copying NC programs
Shifting the horizontal soft-key row
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
TNC 620
Status display for Q parameters
Block functions, e.g.
COPY BLOCK
ACC setting
Miscellaneous
program functions, e.g.
FUNCTION DWELL
Separate soft key for MDI mode
TNC 620
NC programs with more than 100
NC blocks cannot be selected; an
error message is issued
If nesting with PGM CALL results
in more than 100 NC blocks, there
is no test graphic display; an error
message is not issued
You can transfer up to 10 elements
from the CAD viewer to an NC
program.
Copying to and from the directo-
ry TNC:\ is possible with Windows
Explorer
Clicking on the soft-key bar shifts
one soft-key row to the right or left
iTNC 530
The soft key from the Program
Run Full Sequence operating
mode is effective
iTNC 530
NC programs can be selected,
max. 100 NC blocks are displayed,
further NC blocks are truncated in
the display
Nested NC programs can be
simulated
You can transfer up to 31 lines
from the DXF converter to an NC
program.
TNCremo or file manager of
programming station must be used
for copying
Clicking any soft-key bar activates
the respective soft-key row
12
495