Heidenhain Function Users - HEIDENHAIN TNC 620 User Manual
Setup, testing and running nc programs
Hide thumbs
Also See for TNC 620:
- User manual (616 pages) ,
- Operating instructions manual (64 pages) ,
- User manual (521 pages)
Table of Contents
Advertisement
10
You can assign more than one role to a user. If more than one
role is assigned to a user, he will be granted all rights contained
in these roles.
Rights:
HEROS rights
NC rights
PLC rights (OEM)
Rights consist of a combination of functions that cover a task
area of the control, e.g. editing the tool table.
Ensure that every user is only assigned the access rights
he needs. The access rights result from the actions a
user performs on and with the control.
HEIDENHAIN function users
HEIDENHAIN function users are pre-defined users that are
automatically created when the user administration is activated.
Function users cannot be edited.
HEIDENHAIN provides four different function users in the control's
factory default setting.
oem
The oem function user is intended for the machine tool builder.
With oem, you can access the PLC partition of the control.
Function user defined by the machine tool builder
Refer to your machine manual.
The users defined by the machine tool builder can
differ from those pre-defined by HEIDENHAIN.
The machine tool builder's function users can already
be active in legacy mode and replace code numbers.
By entering code numbers or passwords that replace
code numbers, you can temporarily enable rights of
oem function users.
Further information:
sys
With the sys function user, you can access the system partition
of the control. This function user is reserved for use by the JH
Service department.
user
In legacy mode, the user function user is automatically logged
on to the system during control start-up. When the user
administration is active, the user function user has no effect.
The logged-on user of the type user cannot be changed in
legacy mode.
useradmin
The useradmin function user is automatically created when
the user administration is activated. With useradmin, you can
configure and edit the user administration.
414
"Current User", Page 428
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
HEROS functions | User administration
Advertisement
Table of Contents
