Usb Devices On The Control - HEIDENHAIN TNC 620 User Manual

Fundamentals | File management

USB devices on the control

Use the USB port only for file transfer and backup.
Before editing or running an NC program, save it to the
hard disk of the control. This helps to avoid duplicate
data maintenance and prevents potential problems
resulting from data transfer during program run.
Backing up data from or loading onto the control is especially easy
with USB devices. The control supports the following USB block
devices:
Floppy disk drives with FAT/VFAT file system
Memory sticks with the FAT/VFAT or exFAT file system
Hard disks with the FAT/VFAT file system
CD-ROM drives with the Joliet (ISO 9660) file system
The control automatically detects these types of USB devices
when connected. The control does not support USB devices with
other file systems (such as NTFS). The control displays the USB:
TNC does not support device error message when such a device
is connected.
If an error message is displayed when connecting a USB
data medium, check the setting in the SELinux security
software.
Further information:
Page 373
If the control displays the USB: TNC does not support
device error message when using a USB hub, ignore
and acknowledge the message with the CE key.
If the control repeatedly fails to correctly detect a USB
device with the FAT/VFAT or exFAT file system, connect
another device to check the port. If this resolves the
problem, use the properly working device.
Working with USB devices
Refer to your machine manual.
Your machine tool builder can assign permanent names
for USB devices.
The USB devices appear as separate drives in the directory tree, so
you can use the file management functions described in the earlier
chapters.
If a larger file is transferred to a USB device in the file manager,
the control displays a dialog Write access on USB device until
file transfer is completed. The dialog is closed with the HIDE soft
key and file transfer is continued in the background. The control
displays a warning until file transfer is completed.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
"SELinux security software",
3
81