2
2.6
Machining the workpiece
Selecting the Program run, single block or Program
run, full sequence operating mode
You can run NC programs either in the Program run, single block
or the Program run, full sequence operating mode:
Press the operating mode key
The control switches to the Program run, single
block operating mode and runs the NC program
block by block.
You have to confirm each NC block with the
NC start key
Press the Program run, full sequence key
The control switches to the Program run,
full sequence operating mode and runs the
NC program after NC start up to a program
interruption or to the end of the program.
Further information on this topic
Operating modes of the control
Further information:
Running NC programs
Further information:
Selecting the NC program
Press the PGM MGT key
The control opens the file manager.
Press the LAST FILES soft key
The control opens a pop-up window with the
most recently selected files.
If required, use the arrow keys to select the
NC program you want to run. Load with the ENT
key
Starting an NC program
Press the NC start key
The control runs the active NC program.
Further information on this topic
Running NC programs
Further information:
52
"Modes of operation", Page 61
"Program run", Page 255
"Program run", Page 255
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
First steps | Machining the workpiece