Operating The Simulation - HEIDENHAIN TNC 620 User Manual

Setup, testing and running nc programs

Hide thumbs Also See for TNC 620:

Table of Contents

Operating the Touchscreen | Gestures

Operating the simulation

The control offers touch operation with the following graphics:

Programming graphics in the Programming operating mode

3-D view in the Test Run operating mode

3-D view in the Program Run Single Block operating mode

3-D view in the Program Run Full Sequence operating mode

Kinematics view

Rotate, zoom or move a graphic

The control supports the following gestures:

Two-finger drag

HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018

Set the graphic to its original size

Rotate the graphic (only 3-D graphics)

Move graphics

Magnify the graphic

Reduce the graphic