Presetting On Any Axis - HEIDENHAIN TNC 620 User Manual

Setup, testing and running nc programs

Hide thumbs Also See for TNC 620:

Table of Contents

Setup | Presetting with a 3-D touch probe (option number 17)

Presetting on any axis

HEIDENHAIN only gives warranty for the function of the

probing cycles if HEIDENHAIN touch probes are used.

Select the probing function: Press the

POSITION PROBING soft key

Move the touch probe to a position near the

Select the axis and probing direction, e.g. Probe

in direction Z-

Probe: Press the NC Start key

Preset: Enter the nominal coordinate

Load with the SET PRESET soft key

Further information:

from the touch probe cycles to a datum table",

Further information:

from the touch probe cycles to the preset table",

Terminate the probing function: Press the END

HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018

"Writing measured values