HEIDENHAIN TNC 620 User Manual page 321

Pallets | Batch Process Manager (option 154)
Programming operating mode
If the control does not open the pallet table (.p) in the Batch
Process Manager as a job list, proceed as follows:
Select the desired job list
Shift the soft-key row
Press the MORE FUNCTIONS soft key
Press the SELECT EDITOR soft key
The control opens the Select editor pop-up
window.
Select BPM-EDITOR
Confirm your entry with the ENT key
Alternative: Press the OK soft key
The control opens the job list in the Batch
Process Manager.
Program run, single block and Program run, full sequence
operating modes
If the control does not open the pallet table (.p) in the Batch
Process Manager as a job list, proceed as follows:
Press the Screen layout key
Press the key
The control opens the job list in the Batch
Process Manager.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
8
321