Additional Status Displays - HEIDENHAIN TNC 620 User Manual

3
The order of icons can be changed with the optional
machine parameter iconPrioList (no. 100813). Only the
icon for control-in-operation (STIB) is always visible and
cannot be configured.

Additional status displays

The additional status displays contain detailed information on the
program run. They can be called in all operating modes. Exception:
the Programming operating mode. In the Test Run operating
mode, only a limited status display is available.
To switch on the additional status display
Call the soft key row for screen layout
Select the layout option for the additional status
display
In the right half of the screen, the control shows
the Overview status form.
To select an additional status display
Toggle through the soft key rows until the
STATUS soft keys appear
Either select the additional status display directly
with the soft key, e.g. positions and coordinates;
or
use the switch-over soft keys to select the
desired view
Select the status displays described below as follows:
directly with the corresponding soft key
via the switchover soft keys
or by using the next tab key
Please note that some of the status information
described below is not available unless the associated
software option is enabled on your control.
66
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
Fundamentals | Status displays