Ethernet Interface - HEIDENHAIN TNC 620 User Manual

10

10.6 Ethernet interface

Introduction
The control is provided with an Ethernet card as a standard feature
so that you can integrate it into your network as a client.
The control transmits data via the Ethernet card using the following
protocols:
the smb protocol (Server Message Block) for Windows
operating systems, or
The TCP/IP protocol family (Transmission Control
Protocol/Internet Protocol) and with support from the NFS
(Network File System)
Protect your data and your control by running your
machines in a secure network.
Connection possibilities
You can connect the Ethernet card in your control to your network
through the RJ45 connection (X26,1000BaseTX, 100BaseTX and
10BaseT), or directly to a PC. The connection is metallically isolated
from the control electronics.
For a 1000Base TX, 100BaseTX, and 10BaseT connection, use a
twisted-pair cable to connect the control to your network.
The maximum possible cable length depends on the
quality grade of the cable, the sheathing, and the type of
network (1000BaseTX, 100BaseTX, or 10BaseT)
General network settings
Have a network specialist configure the control.
Proceed as follows to access the general network settings:
Press the MOD key
Enter the code number NET123
Press the PGM MGT key
Press the NET soft key
Press the CONFIGURE NETWORK soft key
392
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
HEROS functions | Ethernet interface