Touchscreen Calibration - HEIDENHAIN TNC 620 User Manual
Setup, testing and running nc programs
Hide thumbs
Also See for TNC 620:
- User manual (616 pages) ,
- Operating instructions manual (64 pages) ,
- User manual (598 pages)
Table of Contents
Advertisement
11
Touchscreen calibration
With the Touchscreen Calibration function you can measure and
correct the screen.
Calibrating the touchscreen
Proceed as follows to conduct the functions:
or the menu icon to open the HeROS menu
Select the Touchscreen Calibration menu item
The control starts the calibration mode.
Successively tap on the blinking symbols
If you would like to stop the calibration:
Wait until the screen switches again or press ESC on the
alphabetic keyboard connected via USB
Touchscreen configuration
With the Touchscreen Configuration function you can define the
properties of the screen.
Adjusting sensitivity
Proceed as follows to adjust the sensitivity:
or the menu icon to open the HeROS menu
Select the Touchscreen Configuration menu item
The control opens a pop-up window.
Select the sensitivity
Confirm with OK
Display of the touch points
Proceed as follows to show or hide the touch points:
Press the DIADUR key to open the JH menu
Select the Touchscreen Configuration menu item
The control opens a pop-up window.
Select the Show Touch Points display
Disable Touchfingers to hide the touch points
Enable Single Touchfinger to show the touch point
Enable Full Touchfingers to show the touch points of all
fingers involved
Confirm with OK
446
Operating the Touchscreen | Functions in the taskbar
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
Advertisement
Table of Contents
