Changing The Machine Settings - HEIDENHAIN TNC 620 User Manual

9
9.9

Changing the machine settings

Selecting the kinematics
Refer to your machine manual.
Your machine tool builder configures and enables the
Kinematics selection function.
Danger of collision!
All stored kinematics can also be selected as active machine
kinematics. By this means, all manual movements and
machining operations are executed using the selected
kinematics. All subsequent axis movements pose a risk of
collision!
Use the Kinematics selection function only in the Test Run
operating mode
Use the Kinematics selection function for selecting the
active machine kinematics only as needed
You can use this function to test NC programs whose kinematics
does not match the active machine kinematics. If your machine
tool builder saved different kinematic models in your machine
and enabled them for selection, you can activate one of these
kinematics configurations with the MOD function. When you select
a kinematics model for the test run this does not affect machine
kinematics.
Ensure that you have selected the correct kinematics
in the Test Run operating mode for checking your
workpiece.
338
NOTICE
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
MOD functions | Changing the machine settings