HEIDENHAIN TNC 620 User Manual page 458

12
Parameter settings
DisplaySettings
Position display settings
Position display
With TOOL CALL DL
As Tool Length: The programmed oversize DL is considered to be the change in tool
length for display of the workpiece-based position
As Workpiece Oversize: The programmed oversize DL is considered to be the
workpiece oversize for display of the workpiece-based position
DisplaySettings
Table editor setting
Behavior when deleting tools from the pocket table
DISABLED: Deletion of tool is not possible
WITH_WARNING: Tool deletion is possible, but must be confirmed
WITHOUT_WARNING: Tool deletion is possible without warning
Behavior when deleting a tool's index entries
ALWAYS_ALLOWED: Deletion of index entries is always possible
TOOL_RULES: The behavior depends on the setting of the parameter "Behavior when
deleting tools from the pocket table"
Show the RESET COLUMN T soft key
TRUE: The soft key is displayed and all tools can be deleted from the tool memory by the
user
FALSE: The soft key is not displayed
DisplaySettings
Setting the coordinate systems for the display
Coordinate system for the datum shift
WorkplaneSystem: Datum is displayed in the system of the tilted plane, WPL-CS
WorkpieceSystem: Datum is displayed in the workpiece coordinate system, W-CS
458
Tables and Overviews | Machine-specific user parameters
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018