Goto Function - HEIDENHAIN TNC 620 User Manual

Testing and running | Test run

GOTO function

Using the GOTO key
Jumping with the GOTO key
Use the GOTO key to jump to a specific location in the NC program,
regardless of the active operating mode.
Proceed as follows:
Press the GOTO key
The control opens a pop-up window.
Enter a number
Select the jump statement by soft key, e.g.
move down the number of lines entered
The control provides the following options:
Soft key Function
Move up the number of lines entered
Move down the number of lines entered
Jump to the block number entered
Use the GOTO function only during programming and
testing of NC programs. Use the block scan function
during program run.
Further information:
Block scan", Page 269
Quick selection with the GOTO key
With the GOTO key, you can open the Smart Select window that
makes it easy for you to select special functions or cycles.
Proceed as follows to select special functions:
Press the SPEC FCT key
Press the GOTO key
The control displays a pop-up window showing a
structural view of the special functions
Select the desired function
Cycle Programming User's Manual
Further information:
Opening the selection window with the GOTO key
When the control provides a selection menu, you can use the
GOTO key to open the selection window. This allows you to view
the available entries.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
"Any entry into the NC program:
6
253