HEIDENHAIN TNC 620 User Manual page 167

Setup | Moving the machine axes
Handwheel display
1 Only with HR 550FS radio
handwheel is in the docking station or whether radio operation
is active
2 Only with HR 550FS
bars = maximum field strength
3 Only with HR 550FS radio
battery, six bars = maximum charging state. A bar moves from
the left to the right during recharging
ACTL: Type of position display
4
5 Y+129.9788: Position of the selected axis
6 *: STIB (control in operation); program run has been started or
axis is in motion
7 S0: Current spindle speed
8 F0: Feed rate at which the selected axis is moving
E: Error message
9
If an error message appears on the control, the handwheel
display shows the message ERROR for three seconds. Then the
letter E is shown in the display as long as the error is pending on
the control.
10 3D: Tilted-working-plane function is active
2D: Basic rotation function is active
11
12 RES 5.0: Active handwheel resolution. Path traversed by the
selected axis with a handwheel revolution
STEP ON or OFF: Incremental jog active or inactive. If the
13
function is active, the control additionally displays the current
traversing step
14 Soft-key row: Selection of various functions, described in the
following sections
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
handwheel: Shows whether the
handwheel: Display of field strength, six
handwheel: Charging state of
1
2
3
4
5
7 7 8
12
14
5
7 6
7 9 10 11
13
167