HP 8719ET Reference Manual page 189

Hardkey/Softkey Reference
Analyzer Functions
TRANS: FWD S21 (B/R)
TRANS: REV S12 (A/R)
TRANSFORM MENU
TRANSFORM on OFF
TRANSMISSION
TRIGGER MENU
TRIGGER: TRIG OFF
TRL 3.5 mm HP 85052C
TRL*/LRM* 2-PORT
TRL/LRM OPTION
TRL LINE OR MATCH
TRL THRU
TRL REFLECT
TTL OUT HIGH
TTL OUT LOW
TUNED RECEIVER
UNCOUPLED
UP CONVERTER
5-62
defines the measurement as S
transmission coefficient (magnitude and phase) of the test
device.
defines the measurement as S
transmission coefficient (magnitude and phase) of the test
device.
(Option 010 only) leads to a series of menus that transform
the measured data from the frequency domain to the time
domain.
(Option 010 only) switches between time domain
transform on and off.
leads to the transmission menu.
presents the trigger menu, which is used to select the type
and number of the sweep trigger.
turns off external trigger mode.
selects the HP 85052C cal kit.
leads to the TRL*/LRM* 2-port calibration menu.
selects the TRL/LRM Option Menu, under the modify cal
kit menu.
is used to enter the standard numbers for the TRL LINE
or MATCH class.
is used to enter the standard numbers for the TRL THRU
class.
is used to enter the standard numbers for the TRL
REFLECT class.
sets the TTL output (TEST SEQ BNC) on the back of the
analyzer high.
sets the TTL output (TEST SEQ BNC) on the back of the
analyzer low.
sets the analyzer to function as a tuned receiver only,
disabling the source.
allows the marker stimulus values to be controlled
independently on each channel.
sends the sum frequency of the RF and LO to the R
channel.
, the complex forward
21
, the complex reverse
12