HP 8719ET Reference Manual page 138

CAL KIT [ ]
CAL ZO: LINE ZO
CAL ZO: SYSTEM ZO
CALIBRATE MENU
Center
CENTER
indicates the currently selected cal kit and leads to the
select cal kit menu, which is used to select one of the
default calibration kits available for different connector
types. This, in turn, leads to additional menus used to
define calibration standards other than those in the
default kits (refer to "Modifying Calibration Kits" in the
"Operating Concepts" chapter of the user's guide). When a
calibration kit has been specified, its connector type is
displayed in brackets in the softkey label. The cal kits
available are listed below, refer to the softkey descriptions
for these softkeys for more information.
—
2.4 mm HP 85056
—
2.92* HP 85056K
—
2.92 mm other kits
—
3.5 mm C HP 85033C
—
3.5 mm D HP 85052D
—
7-16 HP 85038
—
7 mm HP 85050
Ω
—
N 50 HP 85054
Ω
—
N 75 HP 85036
—
TRL 3.5 mm HP 85052C
this default selection establishes the TRL/LRM
LINE/MATCH standard as the characteristic impedance.
allows you to modify the characteristic impedance of the
system for TRL/LRM calibration.
leads to the calibration menu, which provides several
accuracy enhancement procedures ranging from a simple
frequency response calibration to a full two-port
calibration. At the completion of a calibration procedure,
this menu is returned to the screen, correction is
automatically turned on, and the notation Cor or C2 is
displayed at the left of the screen.
is used, along with the
range of the stimulus. When the
its function becomes the active function. The value is
displayed in the active entry area, and can be changed
with the knob, step keys, or numeric keypad.
sets the center frequency of a subsweep in a list frequency
sweep.
Hardkey/Softkey Reference
Analyzer Functions
key, to define the frequency
Span
key is pressed,
Center
5-11